How to Make a Network Cable LAN cable or STRAIGHT and CROSS

Posted by : Unknown Wednesday, May 1, 2013

The following stages or HOW TO CABLE LAN in straight and cross

First used to prepare the necessary tools:

UTP cable does not pass through a length of 100 meters

Jack RJ-45

Crimping Tool / Tang Klem

If all the above equipment that we require is available then we can start to MAKE CABLE LAN.
lan cable or the network cable has 2tipe namely:

1. LAN CABLE STRAIGHT
Straight LAN cable is a cable that has a way of mounting the same between one end with the other end. Straight cable is used to connect two different types of devices.
How to make it:

Peel the outer skin around 2cm to UTP cable looks like the wires in UTP cable in the picture above.

Separate cables in and straightens. Arrange and trim based on color White, Orange, White Green, Blue, White Blue, Green, White Chocolate, and Chocolate. Then cut the tip of his so mean to each other.

Insert the wires into the pin RJ-45 Jack in the order

2. LAN CABLE CROSS
Cross LAN cable is a cable that has a way of fixing that have a different arrangement between the end of one with the tip of her again.

Cross cable is used to connect two similar type of device directly. like the first computer with a dial-2 computer directly without using an intermediary.

How to make it:

Do it the same way as a LAN cable to the end of the first straight.

To the other end change in the composition of the cable into the RJ-45: White Green, Green, White Orange, Blue, White Blue, Orange, White Chocolate, Chocolate